Functions; Installing The Water Filter; First Use - Sage the Barista Touch BES880 Guía Rápida De Inicio

Functions

INSTALLING THE WATER FILTER

• Remove the water filter and water filter holder
from the plastic bag.
• Soak the filter in cold water for 5 minutes.
• Wash the filter holder with cold water.
• Set the reminder for next month of replacement.
We recommend to replace the filter after
3 months.
• Insert the filter into the two parts of the
filter holder.
• To install the assembled filter holder into the
water tank, align the base of the filter holder
with the adapter inside the water tank.
Push down to lock into place.
8
• Fill the water tank with cold water before sliding
back into position at the back of the machine and
locking into place.

FIRST USE

1. Press POWER button to turn the machine on.
2. Follow the instructions on screen to guide you
through first use setup.
3. After completing setup, the machine will tell that
it is ready to use.
Your Barista Touch is now ready
Select the guide to find out more about your Barista Touch
or exit to proceed to your drink selection
Exit
The machine is now in STANDBY mode.
4. Touch "Guide" and the machine will guide you
step by step to make your first coffee. Touch the
 and go to the Drinks Menu or < to repeat the
Setup. To repeat the Guide at any time, go to
Settings Menu.
NOTE
If your water hardness is either 4 or 5 when tested,
we strongly recommend you change to an alternate
water source.
GRINDING OPERATION
Insert bean hopper into position on-top of the
machine. Turn dial to lock into place. Fill hopper
with fresh beans.
Guide