GASPARDO FBR Plus Empleo Y Mantenimiento página 36

ENGLISH
- Adjusting the hoisting chain (N, Fig. 24) so that during mowing
the hoisting arm (O, Fig. 24) is free to move up and down; in
this way, the cutting arm can follow any unevenness of the
ground.
So that the mower will work well, we advise you to fix the
chain (N, Fig. 24) to the lifting arm (O, Fig. 24) at the level of the
7th or 8th link of the chain.
- Adjust the heigt of the cutting arm from the ground with chain
(Q, Fig. 25). Lower the mower; when the external tip of the arm
touches the ground, the inner shoe must remain approximately
10 cm. above ground level (Fig. 25). Adjust by moving the chain
links.
So that the mower will work well, we advise you to fix the chain
(Q, Fig. 25) to the equalizer (P, Fig. 24), leaving the last links of
the chain free.
- Adjust inclination of the cutting arm teeth using tie rod (E, Fig.
26).
- The mower may be used with the cutting arm tited for working
on canal, ditches, embankments, etc. by adjusting hoisting
chains (N, Fig. 24) and (Q, Fig. 25) after removing the mowing
guide of the external shoe.
- Adjust the cutting height (Fig. 27) by moving the mowing bar on
the holes of the inner mowing bar support (R), and, turning the
nut of the outer mowing bar support (S), bring it level with the
ground.
36
USE AND MAINTENANCE
Fig. 24
Fig. 25
Fig. 26
R
g
O
7°/8°
N
1°
P
S
Min. 3 cm
Max. 7 cm
cod. G19503010
Q
E
Fig. 27