Mitsubishi Electric Mr.Slim SLZ-KA25VAQ Manual De Instrucciones página 4

2. Parts Names
■ Wireless Remote-Controller [SLZ-KA·VAL(2) only]
ON / OFF button
Pushing button starts operation.
Pushing again stops operation.
MODE SELECT button
This button is used to change
between auto, cooling, heating
and drying operation modes.
■ When using the wireless remote controller, point it towards the receiver on the indoor unit.
■ If the remote controller is operated within approximately two minutes after power is sup-
plied to the indoor unit, the indoor unit may beep twice as the unit is performing the initial
automatic check.
■ The indoor unit beeps to confirm that the signal transmitted from the remote controller has
been received. Signals can be received up to approximately 7 meters in a direct line from
the indoor unit in an area 45° to the left and right of the unit. However, illumination such
as fluorescent lights and strong light can affect the ability of the indoor unit to receive sig-
nals.
■ If the operation lamp near the receiver on the indoor unit is flashing, the unit needs to be
inspected. Consult your dealer for service.
■ Handle the remote controller carefully! Do not drop the remote controller or subject it to
strong shocks. In addition, do not get the remote controller wet or leave it in a location with
high humidity.
■ To avoid misplacing the remote controller, install the holder included with the remote control-
ler on a wall and be sure to always place the remote controller in the holder after use.
■ Outdoor unit
4
h
ON/OFF
TOO TOO
WARM COOL
FAN SELECT
AUTO COOL
VANE TIME
HEAT DRY
MODE
RESET
Power
Ref. Pipes
Indoor-Outdoor
Connection wire
Earth
SET TEMPERATURE button
SET TEMPERATURE button
sets and any desired room
temperature.
TIMER SELECT button
Used for selecting timed starting
or stopping.
FAN SPEED button
This button is used to set fan
speed to low, medium or high.
VANE CONTROL button
Used to change the airflow direc-
tion.
Battery installation/replacement
[SLZ-KA·VAL(2) only]
1. Remove the top cover, insert two AAA batteries,
and then install the top cover.
Top cover
Two AAA batteries
Insert the negative
(–) end of each bat-
tery first. Install the
batteries in the correct
directions (+, –)!
2. Press the Reset button.
Press the Reset button
with an object that has
a narrow end.