Assembling Your Steam Mop - Shark S4701 Serie Guia Del Usuario

Assembling Your Steam Mop

fig. 1
WARNING: Always make sure the Steam Mop
is UNPLUGGED from the wall when not in use.
Never fill the Steam Mop, attach the Mop Head,
or change or remove the Pocket Pad when the
Steam Mop is plugged into the wall. Unplug from
the wall and allow to cool before you fill the
Steam Mop, attach or remove the Mop Head, or
change or remove the Cleaning Pad. To prolong
the life of your Steam Mop, we recommend using
distilled water. Make sure you add only water
to the tank. Chemicals or cleaning solutions
(including vinegar) may damage the Steam Mop
and could be unsafe for you and your family.
STEAM MOP ASSEMBLY
1
Insert the Mop Handle into the Mop Body. (fig. 1) Push
the Mop Handle in until you hear it click into place.
11 1-800-798-7398
fig. 3
fig. 2
2
Select the Rectangle Mop Head and Pocket Pad. If
the Pocket Pad is not already attached, fit one side
of the Pocket Pad onto the Mop Head first, then,
using the loop, pull the Pocket Pad over the Mop
Head. Attach the hook-and-loop fasteners on the top
of the Pocket Pad to secure it in place.
3
Insert the Mop Head into the Mop Body. Push until
you hear it click into place (fig. 2).
4
Attach the Scrubbing Pad to the hook-and-loop
surface of the Stain Scrubber (fig. 3).
5
Pull up on the Water Tank Cap to open (fig. 4).
6
Use the Filling Flask to pour water into the Water
Tank (fig. 5). Do not overfill. Press the Water Tank
Cap firmly to close it.
NOTE: Steps 2–6 also apply to the Triangle Mop Head.
NOTE: The Triangle Mop Head may not be included
with your product. See box for specific product details.
fig. 4
fig. 5