Servo Mode - Metz MECABLITZ 58 AF-2 digital Manual De Instrucciones

18.5 Servo mode

Adjustment procedure for servo flash mode
BEEP
Select
Remote
FB
Set
Servo
Set
Servo
MZoom 35
Para Sel
Setting partial lighting or reflector position (MZoom)
Para
Sel
Set
M
+ –
Wait for all of the flash units involved to become
flash-ready.
Slave groups and remote channels cannot be set
in SERVO mode.
The camera flash unit may not work in the wire-
less remote mode.
When it comes to cameras from Olympus the built-in camera flash unit
or the flash unit in the flash shoe of the camera must be switched to the
manual M mode.
In Panasonic cameras the slave mode is not supported by the built-in
camera flash unit. The slave mode can only be used if a flash unit in the
flash shoe of the camera operates in the manual
Switching Servo flash mode off
Sel
Set
Servo
MZoom 35
Para Sel
M
flash mode.
BEEP
Select
Remote
FB
Set
Remote
OFF
Set