Servo Mode; Setting Servo Flash Mode; Pre-Flash Suppression Or Synchronisation Settings - Metz mecablitz 52 AF-1 Manual De Instrucciones

10.4 SERVO mode

SERVO mode is a simple slave mode without
or with complete pre-flash suppression in
which the slave flash unit always triggers a
flash as soon as the camera flash unit recei-
ves a light pulse.
In SERVO mode, only manual flash mode is
possible. Manual flash mode is automatically
activated after switching to SERVO mode.

10.4.1 Setting SERVO flash mode

• Set the camera to E TTL mode.
• Press the sensor button of the displayed
TTL
mode of operation on the touch display as
-7,9 m
0,7
many times as it takes for the display for
m
Z
F4.0 selecting the mode of operation to appear.
35
OOM
m
EV
INFO
• Press the
SLAVE
touch display and select „SERVO".
SERVO
• Press the
touch display.
The mode of operation is adopted.
If desired, partial light output can be set,
see 10.4.3.
SYNC
M-SERVO
Z
24 mm
OOM
INFO P
sensor buttons on the
SERVO
sensor button on the
10.4.2 Pre-flash suppression or
synchronisation settings
• Set the camera to TTL mode.
• Press the sensor button
SYNC
M-SERVO
touch display as many times as it takes for
the display for selecting the type of
Z
24 mm
OOM
synchronisation.
INFO P
• Press the sensor button on the touch
display:
SYNC
synchronisation without pre-flash
synchronisation with pre-flash
The mode of operation is adopted
If the synchronisation set here does not work
Learn
properly, then proceed as described in
10.4.4.
SYNC
on the
k
167