STARTING AND STOPPING THE UNIT
Proceed as indicated.
Starting
1 -Make sure that safety switch is in
position 1.
2 -Press the switch (C) to enable
the power supply to the controls.
3 -When the display (B) indicates
"GEN OFF", press the button (D)
to start the unit.
If the equipment has just been
stopped and is still hot, press button (D) for a while. If it is cold (it was stopped long
before), press button (D) for a few seconds.
Stopping
4 -Press the switch (C) to turn the unit off.
RECOMMENDATIONS FOR USE
– During the running-in period, (first 50 working hours), the equipment must be used with a
percentage of absorbed load included between 50% and 70% of the maximum power.
– Using the equipment with a percentage of absorbed load lower than 75% of the maximum
power ensures a longer life of its components, o lower maintenance cost and better effi-
ciency.
– In the case of use at low temperatures (lower than 0°C), refill with winter-type fuel, or add
petrol to the fuel.
The table indicates the percentages of petrol to be added to the diesel oil based on the
ambient temperature and the type of fuel used.
C
- 31 -
Use, maintenance and installation instructions
TEC 30D EV
B
D
40200701600.tif
GB