Alarm Messages; Oil Change - Dometic TEC 30D EV Manual De Instrucciones Para El Uso, Mantenimiento E Instalación

ALARM MESSAGES

Each time that the equipment's functioning is irregular an alarm message appears on the
GB
control board display.
Table 7: Alarm list
Alarm
LOW BATTERY
CHECK OIL LEVEL

OIL CHANGE

NO FUEL
OIL TEMP PRESS
GENERATOR ALERT! General alarm
OVERLOAD!
SHORT CIRCUIT
Problem
Battery low
Shows that the motor oil level
must be checked
Indicates that it is necessary to
change the engine oil
Fuel level too low
Insufficient oil in engine
Motor temperature too high
Requested power higher than 2,5
kW
Output cable short-ircuit
- 42 -
Remedy
Change the battery
Top up with oil of the same type
Change the engine oil (See
"Changing engine oil")
Important
When the equipment is restar-
ted, keep the ON switch pres-
sed for a long time in order to
reset the alarm.
Fill up with fuel
Top up with oil of the same type
Switch the appliance off and lea-
ve it to cool. Verify that the air soc-
kets used to cool the equipment
are not obstructed.
Important
If the problem persists, contact
the service department
See "Finding malfunctions"
Important
If the problem persists, contact
the service department
Decrease the required load
Eliminate the short-circuit
Use, maintenance and installation instructions
TEC 30D EV