HEINE HSL 150 Manual De Instrucciones página 7

The slide control (3) can be used to adjust the size of the slit. The loupe provides magnification in the left and
right working position.
With the loupe attachment HSL 10x (5), the magnification is increased by 10x. See figures
HEINE HSL 150 is intended for a brief examination of less than 2 minutes with a 15 minutes break until the
next application.
The setup and operation of the HEINE handles are described in a separate instruction for use.
Hygienic reprocessing
The instruction is available:
- at www.heine.com
- in a paper version which you can request from the address listed
Maintenance
The device is maintenance free.
Service
The device has no components serviceable by the end-user.
General Notes
The warranty for the entire product is invalidated if non-genuine HEINE products or non-original parts
are used and if repairs or modifications are made to the device by persons not authorized by HEINE.
For more information, please visit www.heine.com.
The expected life cycle, when the device is normal used and the warning and safety information as well
as the maintenance instructions are observed, is up to 7 years. Beyond this period, the product may
continue to be used if it is in a safe and good condition.
If you don't use the device for a longer period of time, please remove the batteries in advance.
Caution – The light emitted from this instrument is potentially hazardous. The longer the duration of
exposure, the greater the risk of ocular damage. Exposure to light from this instrument when operated
at maximum intensity should not exceed 23 min (at a distance of 30 mm).
General Warnings
Check the correct operation of the device before use! Do not use the device if there are visible signs of
damage or the light begins to flash.
Do not use the device in fire- or explosive risk area (e.g. oxygen saturated or anaesthetic environments).
Do not modify the device.
Use only original HEINE parts, spare parts, accessories and power sources.
Repairs shall only be carried out by qualified persons.
Disposal
The product must be recycled as separated electrical and electronic devices. Please observe the
relevant state-specific disposal regulations.
The appendix contains following tables
- Electromagnetic disturbances – Requirements and tests
- Technical specification
- Explanation of the used symbols
MED 2314 2020-07-10
➀ ➁ ➂
(Page 3).
7/28