GYS STARTIUM 330E Manual Del Usuario página 13

Translation of the original instructions
• If your eyes or skin come into contact with battery acid, rinse the
affected part of the body with plenty of water and seek imme-
diate medical assistance.
Connection / disconnection:
• Disconnect the power supply before connecting/disconnecting
the device to/from the battery
• The terminal of the battery that is not connected to the car frame
must be connected first. The other connection must be made on
the car frame, far from the battery and the fuel line. The battery
charger must be connected to the power supply network.
• After the charging process, disconnect the battery charger from
the power supply network and remove the connector from the
car frame and then the connector from the battery, in this order.
Connection:
• This device must be connected to an earthed power supply.
• This machine is fuse-protected.
• Connection to the mains must be made according to the natio-
nal installation regulations.
• This equipment is intended for industrial environments (class A)
and not for residential sites where the electric current is supplied
by the public low-voltage power supply network. There may be
potential difficulties in ensuring electromagnetic compatibility on
680E and
these sites, because of the conducted interferences, as well as
980E only
radiated radioelectrical frequency.
• This product does not comply with IEC 61000-3-12 and is in-
tended to be connected to private low voltage networks which
are connected to public supply network only at the medium and
high voltage level. If connected to a public low-voltage supply
680E and network, it is the responsibility of the installer or user of the equip-
980E only ment to ensure, by consulting the operator of the electrical distri-
bution network, that the hardware can be connected.
Maintenance:
• If the power supply cable is damaged, it must be replaced by the
manufacturer, its service agent or an equally qualified person.
• Service should be performed by a qualified person.
• Warning! Always remove the power plug from the wall socket
before carrying out any work on the device.
• If the internal fuse is blown, it must be replaced by the manufactu-
rer, its after-sales service or an equally qualified person.
• Regularly take off the cover and remove dust with an air gun.
Take the opportunity to have a qualified person check the electri-
cal connections with an insulated tool.
• Under no circumstances should solvents or other aggressive clea-
ning agents be used.
STARTIUM 330E / 480E / 680E / 980E EN
13