GYS STARTIUM 330E Manual Del Usuario página 15

Translation of the original instructions
12V
Charging
capacity
24V
Connection
1.
2.
3.
4.
5.
Disconnection
6.
STARTIUM 330E / 480E / 680E / 980E
STARTIUM 330E STARTIUM 480E
20 - 375 Ah
20 - 300 Ah
Plug the connector into the «12 V» or «24 V» position of the STARTIUM according to the
battery to be charged or started.
Connect the clamps (several possible cases):
a. The negative terminal is plugged onto the car's chassis :
- Connect the red clamp to the battery's positive terminal.
- Connect the black clamp to the vehicle's chassis, make sure it is a safe distance from
the battery and the fuel/exhaust pipe.
b. The positive terminal plugged onto the car chassis, in this event :
- Connect the black clamp to the battery's negative terminal.
- Connect the red clamp to the vehicle's chassis, make sure it is a safe distance from
the battery and the fuel/exhaust pipe.
c. Battery disconnected from the vehicle :
Connect the red clamp to the battery's positive terminal and the black clamp to the
battery's negative terminal.
Connect the device to the mains.
Press the ON / OFF button.
A LED, (8) or (10) switches on under the corresponding interface to confirm the selected
voltage input. If the selected voltage does not match the battery voltage, the charge cannot
start.
STARTIUM 330E
Once connected, the STARTIUM provides information on the battery's health status. The
display (2) alternately indicates the actual voltage (4) and the percentage of charge (5).
12V
100%
> 12,8 V
... 11,8 V < tension < 12,8 V
0%
< 11,8 V
Use the STARTIUM in charger, starter or alternator test mode.
After use, carry out the exact reverse operation for the disconnection phase in order.
STARTIUM 680E
20 - 600 Ah 20 - 675 Ah
20 - 450 Ah 20 - 525 Ah
STARTIUM 480E-680E-
> 25,6 V
23,6 V < tension < 25,6 V
< 23,6 V
STARTIUM 980E
20 - 750 Ah
20 - 525 Ah
980E
24V
EN
15