Lavorwash TUSCON Manual De Uso página 22

EN
effective from the date of purchase.
The following are not included in the warran-
ty: - Parts subject to normal wear. - Rubber parts,
charcoal, filters and the accessories and optional
accessories. - Accidental damage, caused by trans-
port, neglect or inadequate treatment, incorrect or
improper use and installation failing - The warranty
shall not cover any cleaning operations to which
the operative components may be subjected, such
as clogged nozzles and filter blocked due to lime-
stones.
> DISPOSAL
As the owner of electrical or electronic
equipment, the law (in accordance with the EU
Directive 2012/19/EU on waste from electrical and
electronic equipment and the national laws of the
EU Member States that have implemented this Directive)
prohibits you from disposing of this product or its electri-
cal / electronic accessories as municipal solid waste and
obliges you to make use of the appropriate waste collec-
tion facilities. The product can be disposed of by returning
it to the distributor when a new product is purchased. The
new product must be equivalent to that being disposed of.
Disposing of the product in the environment can cause
great harm to the environment itself and human health.
The symbol in the figure indicates the urban waste con-
tainers and it is strictly prohibited to dispose of the
equipment in these containers. Non-compliance with the
regulations stipulated in the Directive 2012/19/EU and the
decrees implemented in the various EU Member States is
administratively punishable.
> REPAIRS - SPARE PARTS
For any problems not mentioned in this manual,
or if the machine breaks down, you are urged
to contact an Authorized After-Sales Service
for the relative repair or for any replacement of
components with original spare parts. Use ex-
clusively original replacement parts.
> TROUBLESHOOTING
Before doing any work on the machine, disconnect
the electricity and water supplies and discharge the
pressure. Proceed systematically to identify faults
following the chart below; if you are still unable to
eliminate the problem, call in the Authorized After-
Sales Service.
Fault
Cause
Repair
Fault
Cause
Repair
Fault
Cause
22
When switch "ON" the
machine will not start wor-
king
- Plug not properly inserted in
socket.
- Electric socket is faulty.
- The main voltage is insuf-
ficient.
- The pump is stuck.
- Gauge of extension lead not
sufficient.
- Fit plug in power socket
correctly.
- Have electrical socket
checked.
- Have a check made on the
suitability of the mains
system.
- Turn switch to ON while
keeping nozzle trigger
pressed; if problem persists,
contact an authorised ser-
vice centre.
- Refer to maintenance sec-
tion.
The motor stops suddenly
- Thermic safety switch has
tripped due to the overheat-
ing.
- Cable extension seems to
be inadequate.
- Leave motor to cool for a
few minutes. If the problem
persists, contact
authorised service centre.
- Refer to maintenance
section.
The pump doesn't reach
the necessary pressure
- Insufficient flow.
- Water inlet filter is clogged.
- Suction/delivery valves are
clogged or worn out.
- Pressure regulator valve
set on minimum.
- The nozzle is worn out.
an