Water Supply; Important - Lavorwash TUSCON Manual De Uso

> DESCRIPTION OF THE MACHINE
(pict.3,4)
①
Handle
②
Pressure control
③
Pressure-gauge
④
High pressure water outlet
⑤
Water inlet + filter
⑥
Power cord
⑦
ON/OFF switch
⑧
Detergent tank
⑨
H.P. nozzle
⑩
Rubber hose fitting
⑪
Lance
⑫
High pressure hose
⑬
Gun trigger lever
⑭
Spray gun
> WATER SUPPLY
Water supply connection
WARNING: (synbol) machine not suitable
for connection to the potable water mains.
Caution - Danger!
Only clean or filtered water should be used for
intake. The delivery of the water intake tap
should be equal to the double of the maxi-
mum pump range.
- Minimum delivery rate: 20 l/ min.
- Maximum intake water temperature: 40°C
- Max inlet water pressure: 1Mpa
Place the cleaner as close to the water supply
system as possible.
Water supply from the water main
- (pict.5 pos. ⑤) Connect a supply hose (not
included) to the water inlet of the unit and to
the water supply (max. pressure 10 bar).
- (pict.6 pos. ④) Connect high pressure hose to
the machine connection and turn on the water
tap.
The cleaner can be connected directly to the
mains drinking water supply hose is fitted
with a backflow preventer valve as per cur-
rent regulations in force.
Make sure that the hose is at least Ø 13 mm and
that it is reinforced.
Failure to comply with the above conditions
causes serious mechanical damage to the
pump and the loss of warranty cover.
> HIGH PRESSURE HOSE
• WARNING: The high pressure hose is designed
and produced to withstand high pressures. To
avoid damage, it must be handled with special
care.
Misuse may lead to premature breakages or dam-
age and cause the loss of warranty cover. See
illustrations (pict.24). Use the hydrocleaner only
if the hose is completely uncoiled and extended.
> ELECTRICITY SUPPLY
- The appliance's electrical connection must
comply with the IEC 364 standard.
IMPORTANT: Before connecting the appli-
ance, make sure that the nameplate data are
the same as those of the electrical mains and
that the socket is protected by a differential
security breaker with tripping sensitivity below
0.03 A - 30 ms.
- If the appliance's plug is not compatible with
the socket, have the socket replaced with an-
other of suitable type by professionally quali-
fied staff.
- Never use the appliance in ambient tempera-
tures below 0° C if it is equipped with a PVC (H
VV-F) cable.
Check that the mains voltage is the same as that of
your machine, indicated on the technical data
plate. Your electrical system must be constructed
by qualified technicians capable of working in
accordance with the requirements of the regula-
tions in force (earth connection, fuses, differential
security breaker, etc).
In case of failure to comply with one of the regu-
lations stated above, the manufacturer de-
clines all responsibility for the staff and pro-
vides no warranty.
IMPORTANT: Regarding three-phase motors,
pay attention to the connection of the electric
cable to the plug (see electric diagram).
• XY WARNING: Inadequate extension cords
can be dangerous.
• XJ WARNING: If an extension cord is used, the
plug and socket must be of watertight construc-
tion.
Information for supply may also be obtained from
the plug manufacturer.
230-240V
3G 2,5 mm 2
max 20 m
19
EN
400-415V
4G 2,5 mm 2
max 30 m