Setting Time Dry - Maytag NEPTUNE MD75 Manual Del Usuario

U
C
SING THE
Press "start/pause" or
change your selection below.
options
dryness level
normal dry cycle chime loud
remind chime ON
regular
temperature
Step 4
Review Screen – The Review Screen lists the selected
settings. At this point you may press Start/Pause to
begin drying the load or select "Options" for further
customization of the drying cycle.
Press "start/pause" or
change your selection below.
options
dryness level
normal dry
cycle chime loud
remind chime ON
regular
temperature
Step 6
Review Screen – The review screen will appear
once again to verify your selections. If they are
correct, press Start/Pause. If they are incorrect,
press the area you would like to change.
S T D
ETTING IME RY
Home
sensor dry
air fluff
time dry
(no heat)
more cycles favorites
Step 1
Select "Time Dry" from the Home screen. The control defaults to
45 minutes.
ONTROLS
CONT
Press "start/pause" or
change your selections below.
time
45 min
regular
temperature
.
Options
Step 5
Options Screen – The option choices on the left
turn the options on or off. The option choices on
the right show an additional screen with multiple
choices. The following options may be added to cus-
tomize your Sensor Dry cycle:
• "Wrinkle Prevent" - Intermittent tumble in
room temperature air for up to two hours fol-
lowing the dry cycle.
• "Damp Dry Chime" - Chimes when load is
damp.
• "Remind Chime" - Chimes at the end of the
cycle every 5 minutes for up to two hours.
• "End of Cycle Chime" - Chimes once when the
selected dryness level is reached.
When the desired selections are made, touch
"Continue" to see the review screen once again.
Special Note: As you use the touchscreen,
if you feel you are lost, press Back or Home.
options
cycle chime loud
remind chime ON
Step 2
7
loud end
of cycle chime
continue
Press "start/pause" or
change your selection below.
Time
options
time
45
45 min
cycle chime loud
minutes
remind chime ON
regular continue
temperature
Press the up and down arrows to set the appro-
priate number of minutes to dry the load. The time
will increase or decrease in one minute increments.
Press "Continue" when done.