Progress PDV9175B Manual De Instrucciones página 53

Before carrying out any maintenance, disconnect the
•
appliance from the power supply.
CAUTION: Accessible parts may become hot during use
•
with cooking appliances.
Use only the fixing screws supplied with the appliance if
•
not supplied, use the screws recommended in the
installation instructions.
Do not use adhesives to fix the appliance.
•
The minimum distance between the hob surface on which
•
the pans stand and the lower part of the appliance shall be
at least 65 cm, unless otherwise specified in the
installation instructions for the appliance or hob.
The discharge of air must comply with local authorities
•
regulations.
Ensure good air ventilation in the room where the
•
appliance is installed to avoid the backflow of unwanted
gases into the room from appliances burning gas or other
fuels, including open fires.
Make sure that the ventilation openings are not blocked
•
and the air collected by the appliance is not conveyed into
a duct used to exhaust smoke and steam from other
appliances (central heating systems, thermosiphons,
water-heaters, etc.).
When the appliance operates with other appliances the
•
maximum vacuum generated in the room should not
exceed 0.04 mbar.
Make sure not to cause damage to the mains cable.
•
Contact our Authorised Service Centre or an electrician to
change a damaged mains cable.
If the appliance is connected directly to the power supply,
•
the electrical installation must be equipped with an
isolating device that allows to disconnect the appliance
from the mains at all poles. Complete disconnection must
comply with conditions specified in the overvoltage
category III. The means for disconnection must be
incorporated in the fixed wiring in accordance with the
wiring rules.
Progress 53