Water Connection - Diamond AL4S/F Manual De Instalación, Uso Y Mantenimiento

ENGLISH
8.4.

Water connection

!
The appliance must be supplied with
drinking water.
The ultrasonic
demineralised water. If you were to use normal
water this will decrease the life of the transducers,
in particular the maintenance interval for cleaning
or replacement of the transducers.
Below the minimum requirements to be met :
GB
Description
Pressure
Temperature
pH
Hardness
Dry Residue
Iron
Manganese
Chlorides
Sulphates
!
Once the installation is completed, flush out
the supply line for few minutes by piping water
directly into the drain without sending it into the
humidifier. This will eliminate any dross or
processing residues that may block the inlet valve.
humidifier works
Value
100÷600 kPA - 1÷6 bar
1÷40 °C
6.5÷8
0÷3°F - (0÷30 mg/l CaCO3)
<1500 mg/L
< 0,1 mg/l
<0,05 mg/l
<0,1 mg/l
<0,25 mg/l
1
2
To carry out connection, connect the mains pipe
to the appliance connection pipe (ø ¾") (1),
interposing a shut-off cock (A)
with
water supply when necessary. Downstream from
this, install some easily reachable filters.
The water temperature must be between 5°C and
50°C.
The water pressure must be enough to guarantee
a correct functioning (see the following table).
Connect the safety discharge (2). Arrange a
funnel to grant the continuity interruption of the
draining pipe (3). Connect a drain trap to prevent
the return of odours (4).
USCITA ACQUA
WATER OUTLET
2
3
4
106 39376
!
Do not add disinfectants or corrosion
inhibiters in the water, as these are potential
irritants; it is absolutely forbidden to use well or
industrial water, or water from cooling circuits and,
in general, of potentially contaminated water
(chemically or bacteriological).
22
to interrupt the
INGRESSO ACQUA
WATER INLET
1
WATER
INLET
WATER
NON ACCENDERE LA
DRAIN
MACCHINA FINO A CHE
NON E' COLLEGATA
L'ALIMENTAZIONE IDRICA
DO NOT TURN THE
MACHINE UNLESS IT IS
CONNECTED TO THE
WATER SUPPLY