Mounting The Kombitool; Mounting The Bar And Chain - Stihl HT-KM Manual De Instrucciones

Mounting the KombiTool

2
1
4
3
Mounting
: Engage lug (1) on drive tube in
slot (2) in the coupling sleeve and
push home the drive tube as far as
stop.
: When correctly installed, the red
line (3) (arrow point) must be flush
with the end of the coupling sleeve.
: Tighten the wing screw (4) firmly.
Removing
: Reverse the above sequence to
remove the drive tube.
HT-KM

Mounting the Bar and Chain

: Unscrew nut and take off cover.
1
2
: Turn tensioning screw (1)
counterclockwise until the
tensioning nut (2) butts against the
left end of the housing slot, then
back it off 5 full turns.
English / USA
The chain is very sharp – wear work
gloves to protect hands from cuts.
: Fit the chain –
start at the bar nose.
17