Dyna-Glo DGC310CNP Manual Del Usuario página 11

ASSEMBLY INSTRUCTIONS
9. Pre-assemble two M6x12 bolts (AA) onto the
upper of left brace of hood and grill body
assembly (B) and do not tighten them and
make sure to leave a 5mm gap between the
bolt and left brace of hood and grill body.
Hang one of the Side Table Assembly (F)
on the bolts and fasten the Side Table
Assembly (F) with two M6x12 bolts (AA). Then
tighten all the four bolts.
Hardware Used
AA M6x12 Bolt
10. Pre-assemble two M6x12 bolts (AA) onto
the upper of right brace of hood and grill body
assembly (B) and do not tighten
them and make sure to leave a 5mm gap
between the bolt and right brace of hood
and grill body. Hang one of the Side Table
Assembly (F) on the bolts and
fasten the Side Table Assembly (F) with two
M6x12 bolts (AA). Then tighten all the four
bolts.
Hardware Used
AA
M6x12 Bolt
9
F
AA
x 4
Wheel axle
10
x 4
Wheel axle
11
5mm
Cotter pin
5mm
F
AA
Cotter pin