Dyna-Glo DGC310CNP Manual Del Usuario página 8

ASSEMBLY INSTRUCTIONS
3. Use four M4x12 bolts (DD) to assemble the
cart front panel (R) between the Right Front
Leg Assembly (O) and Left Front Leg
Assembly (L).
Note: The small edge of the front panel (R)
should be on top.
DO NOT TIGHTEN BOLTS AT THIS TIME.
Hardware Used
DD M4x12 Bolt
Cotter pin
4. Use four M6x12 bolts (AA) Fasten the Cart
Rear Upper Brace Assembly (H) onto Left
Rear Leg Assembly (J) and Right Rear Leg
Assembly (N).
Note: Follow the arrow direction on the Cart
Rear Upper Brace Assembly (H)
when installing.
DO NOT TIGHTEN BOLTS AT THIS TIME.
Hardware Used
AA
M6x12 Bolt
3
x 4
O
4
x 4
Wheel axle
8
DD
R
L
AA
H
Cotter pin
N J