ELICA ENS436BL Manual De Instrucciones página 21

• press (10)
• within 10 seconds scroll to the right along
bar (3), relating to the cooking zone 2 (FIG.19);
Note : if the operation is not performed within this time the
pause function will remain active.
Note: if after 10 minutes, the Pause Function is not
deactivated, the hob will turn off automatically.
Recall
The Recall function allows to recover all the hob settings, in
case of accidental shut-down.
Activation:
• turn the hob back on
down
• press within the next 6 seconds
Automatic Heat UP
The Automatic Heat UP function allows to reach the set power
faster; with this function it is possible to cook food faster, but
without the risk of burning it, because the temperature does
not exceed the set level.
This function is available for the levels of power 1 -8 .
Activation:
• press and hold, on the Selection bar (3), the desired power
• a " " is displayed (13).
USING THE EXTRACTOR FAN
Power-on
Press (touch) ON/OFF(1) hob/ extractor
The indicator light will turn on to indicate that the hob/extractor
is ready for use
Press again to turn off
Note: This function has priority over the others.
Switching on the extractor fan:
Touch (press) the Selection bar (6) to activate the extractor
fan
Extraction speed (power):
Touch and scroll along the Selection bar (6):
to the right to increase the speed (power) of the extractor fan
(0-4);
to the left to decrease the speed (power) of the extractor fan
(4-0);
Timer
Activation/Regulation of Timer function for the extractor
fan
• Select the extractor fan (speed ¹ 0).
• Press (8) to access the Timer function (from any
speed)
• Regulate the duration of the Timer:
the Selection
within 6 seconds after shut-
press the selector , to increase the automatic shut-down time
press the selector , to decrease the automatic shut-down time
the display (15) will show the countdown,
Note: on the side of the display of the extractor fan, with the Timer
in use, the following symbol will appear
When the timer has finished the countdown, there is an acoustic
signal (for 2 minutes, or it will stop when one of the buttons on the
hob is pressed), while the display (15) will flash, with the symbol
" . ".
To switch off the Timer:
• select the cooking zone
• set the value of the timer to " " , by means of
Not: the function remains active if no other key is pressed in the
meantime.
Filter saturation indicator
The hood indicates when filter maintenance is needed:
"
Grease filter the
Activated carbon odour filter the
Reset filter saturation
After carrying out maintenance on the filters (grease and/or
activated carbon) hold down the
" "
the LED turns off and the count restarts.
Activation of activated carbon odour filter saturation
indicator
This indicator is normally deactivated.
To activate it, proceed as follows:
- turn on the aspiration hob by pressing
- with the aspiration motor and cooking zones off, press and hold
;
" "
- turns on, then off to indicate successful activation.
Deactivation of activated carbon odour filter saturation
indicator
repeat the activation steps described above
" "
flashes, then turns off to indicate successful
deactivation.
Automatic mode
The hood will turn on at the most suitable speed, adapting the
extraction capacity to the maximum cooking level used in the
cooking zone.
Once the hob is turned off, the hood adapts its aspiration speed,
gradually decreasing it, so as to eliminate residual vapours and
odours
To activate this function:
Briefly press (7), the LED "
that the hood is working in this mode.
21
(19)
"
(17) LED lights up
" "
(17) LED flashes
key;
;
" (18) will light up to indicate