Installation; Preparation Of The Hood For Installation - ELICA ENS436BL Manual De Instrucciones

Installation

The electrical and mechanical installation must be performed by qualified personnel.
The electrical appliance is designed to be built-in to a 2-6 cm thick worktop in the case of TOP installations; 2.5-6 cm in the case
of FLUSH installations.
The minimum clearance between the cooktop and wall must be at least 5 cm at the front, at least 4 cm on the side and at least
50 cm with respect to the wall units above.
NB = The suggested clearances are indicative: when designing the spaces, follow the instructions of the kitchen
manufacturer.

Preparation of the hood for installation:

Before starting the installation:
After unpacking the product, check that it has not
•
been damaged during transport and in the case of
problems, contact your dealer or Customer
Service, before proceeding with the installation.
• Check that the product is the right size for the
installation location.
Check for accessories inside the packaging (placed
•
there for ease of transport) such as bags containing
screws, the warranty card, etc.. Remove them and
keep them safe.
Also check that there is a power socket near the
•
installation area
Preparing the cabinet for installation:
- The product cannot be installed above cooling
appliances, dishwashers, heaters, ovens, washing
machines and dryers.
- Cut the cabinet before inserting the hob and carefully
remove shavings or sawdust.
CAUTION! Failure to install screws and fasteners in
accordance with these instructions may result in electrical
hazards.
Note: to ensure the correct installation of the product, it is
recommended to tape the pipes using an adhesive with
the following characteristics:
- soft elastic PVC film, with an acrylic-based adhesive
- which complies with DIN EN 60454 regulations
- flame retardant
- excellent resistance against wear
- resistant against temperature fluctuations
- can be used in low temperatures
IMPORTANT: use a single component adhesive
sealant (S), resistant against high temperatures up to
250°;
prior to installation, the surfaces that need to be glued
must be carefully cleaned, removing all substances
that may compromise adhesion
(e.g. release agents, preservatives, grease, oils,
powders, old adhesive residue, etc.);
the sealant must be evenly distributed along the entire
perimeter of the frame;
after gluing, leave to dry for approximately 24 hours.
Fig. 1b
4-Wire Cable from Home Power Supply to
4-Wire Cable from Cooktop
IMPORTANT: Use the 4-wirw cable from
home power supply in the U.S. where local
codes do not allow grounding through homes
and recreational vehicles, new construction,
and in Canada
A. Cable from home power supply
B. Black wires
C. Green or yellow-green ground wires
D. 4-wire cable from cooktop
E. Junction box
F. White wires
G. UL listed wire connector
H. red wires
I. UL listed or CSA approved conduit connector
1. Connect the 2 black wires together using the
UL listed wire connectors
2. Connect the 2 red wires together using the
UL listed wire connectors
3. Connect the 2 white wires together using the
UL listed wire connectors
15