Cutting Warped Material; Clamping Wide Workpieces - Ryobi P3650 Manual Del Operador

Ocultar thumbs Ver también para P3650:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CUTTING WARPED MATERIAL

See Figures 39 - 40.
When cutting warped material, always make sure it is
positioned on the miter table with the convex side against
the fence as shown in Figure 39.
If the warped material is positioned the wrong way as shown
in Figure 40, it will pinch the blade near the completion of
the cut.
WARNING:
To avoid a kickback and to avoid serious personal injury,
never position the concave edge of bowed or warped
material against the fence.

CLAMPING WIDE WORKPIECES

See Figure 41.
When cutting wide workpieces, such as 2 in. x 6 in., boards
should be clamped with a work clamp as shown in Figure 41.
All manuals and user guides at all-guides.com
OPERATION
RIGHT
Fig. 39
29 − English
WRONG
Fig. 40
WIDE
BOARD
Fig. 41

Publicidad

Tabla de contenido
loading

Tabla de contenido