Parts Description; Bench Mounting - Makita DLS714 Manual De Instrucciones

Tips for maintaining maximum
battery life
1. Charge the battery cartridge before completely
discharged. Always stop tool operation and
charge the battery cartridge when you notice
less tool power.
2. Never recharge a fully charged battery car-
tridge. Overcharging shortens the battery
service life.

PARTS DESCRIPTION

► Fig.2
1 Lock-off button
Adjusting bolt (for maxi-
5
mum cutting capacity)
9 Blade guard
13 Lock lever (for turn base)
17 Pointer (for miter angle)
Sub-fence
21
► Fig.3
Slide pole (upper)
22
26 Lever (for bevel angle
adjustment)
INSTALLATION

Bench mounting

WARNING:
Ensure that the tool does not
move on the supporting surface. Movement of the
miter saw on the supporting surface while cutting may
result in loss of control and serious personal injury.
Fix the base to a level and stable surface, screw-
1.
ing with two bolts. This helps to prevent from tipping and
possible injury.
► Fig.4: 1. Bolt
Turn the adjusting bolt clockwise or counterclock-
2.
wise so that it comes into a contact with the floor sur-
face to keep the tool stable.
► Fig.5: 1. Adjusting bolt
Switch trigger
2
Stopper arm
6
10 Vertical vice
14 Grip (for turn base)
Turn base
18
- -
Thumb screw (for lock-
23
ing upper slide pole)
Slide pole (lower)
27
15 ENGLISH
3. Charge the battery cartridge with room tem-
perature at 10 °C - 40 °C (50 °F - 104 °F). Let
a hot battery cartridge cool down before
charging it.
4. Charge the battery cartridge if you do not use
it for a long period (more than six months).
3 Blade case
7 Dust bag
11 Guide fence
Adjusting bolt (for turn
15
base)
19 Holder assembly
- -
24 Hex wrench
Thumb screw (for lock-
28
ing lower slide pole)
Installing the holders and holder
assemblies
NOTE: In some countries, the holders and holder
assemblies may not be included in the tool package
as standard accessory.
The holders and the holder assemblies support work-
pieces horizontally.
Tighten the fence shafts to the holder assemblies using
the hex wrench.
► Fig.6: 1. Holder 2. Holder assembly 3. Fence shaft
4. Hex wrench
Install the holders and the holder assemblies on both
side as shown in the figure. When installing, make sure
that the fence shaft is in the same line of the guide
fence when installed to the tool.
► Fig.7: 1. Holder 2. Holder assembly 3. Screw
Then tighten the screws firmly to secure the holders and
the holder assemblies.
Adjusting screw (for
4
lower limit position)
8 Bevel scale
12 Holder
16 Kerf board
Fence shaft
20
- -
25 Clamp screw (for locking
holder)
- -