D-Fi™ 2.4 Ghz (Ir/Standalone Mode Manual Sync) - Chauvet FREEDOM PAR Manual De Instrucciones

D-Fi™ 2.4 Ghz
(IR/Standalone
Mode Manual
Sync)
Page 22 of 76
The Freedom™ PAR and Strip Mini can be configured to control 2 or more products with
no external controllers or with the IRC from CHAUVET® (sold separately). To manually
set up D-Fi™ syncing for IR/standalone functionality:
For the transmitting product:
1. Press <MODE> repeatedly until SYS, ACt, SLAv, or S-1r shows on the display.
2. Use <UP> or <DOWN> to select SYS.
Press <ENTER>.
3.
4. Press <UP> or <DOWN> until S-tr appears on the display.
5. Press <ENTER>.
6. Press <UP> or <DOWN> until t.CH appears on the display.
7. Press <ENTER>.
8. Use <UP> or <DOWN> to select the transmitting signal (t001–t016).
For the receiving product(s):
1. Press <MODE> repeatedly until SYS, ACt, SLAv, or S-1r shows on the display.
2. Use <UP> or <DOWN> to select SLAv.
3. Press <ENTER>.
Press <UP> or <DOWN> until r-st appears on the display.
4.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select the receiving signal (r001–r016). The channel
number should match the transmitting signal you chose in the prior steps.
Once the steps above are done, you can then back out and configure the transmitting
product to operate it in either Automatic Mode or with an IRC (sold separately).
To configure your product to work in Automatic Mode, refer to the
section of the Operation section.
To configure your product to work with the CHAUVET® IRC, refer to the
Remote Control) section.
If you are experiencing antenna issues or need to improve signal quality, extend the
antenna outward away from the product and keep the line of sight between products
unobstructed.
Ensure that all linked products are configured to the same DMX personality (either
3-channel or 4-channel).
To sync multiple transmitters in one room, manually set each receiver and the
designated transmitter to a specific frequency and then perform the syncing steps.
Freedom™ PAR/Strip Mini User Manual (Rev. 8 ML)
Automatic Mode
IRC (Infrared