Preparing Trimmer For Operation; Preparing The Brushcutter For Operation; Charging The Battery, Leds; Mounting The Charger On A Wall - Stihl FSA 60 R Manual De Instrucciones

English
attachment, battery or charger are not cleaned correctly,
components may no longer function properly or safety
devices may be rendered inoperative. This can result in
serious injuries.
► Clean the trimmer, deflector, cutting attachment, battery
and charger as described in this instruction manual.
￭ If the trimmer, deflector, cutting attachment, battery and
charger are not properly serviced or repaired, components
may no longer function properly or safety devices may be
rendered inoperative. This can result in serious or fatal
injuries.
► Do not attempt to service or repair the trimmer,
deflector, cutting attachment, battery or charger.
► If the trimmer, deflector, cutting attachment, battery or
the charger require servicing or repairs: Contact a
STIHL servicing dealer for assistance.

5 Preparing Trimmer for Operation

5.1

Preparing the Brushcutter for Operation

The following steps must be performed before commencing
work:
► Ensure that the following components are in safe
condition:
– Brushcutter, @ 4.6.1.
– Deflector, @ 4.6.2.
– Mowing head, @ 4.6.3.
– Battery, @ 4.6.4.
– Charger, @ 4.6.5.
► Check the battery, @ 11.2.
► Fully charge the battery, @ 6.2.
► Clean the brushcutter, @ 16.1.
► Mount the bump guard, @ 7.1.
► Mount the deflector, @ 7.2.
► Mount the loop handle, @ 7.3.
► Mount the mowing head, @ 7.4.1.
44
► Adjust the loop handle, @ 8.1.
► Check the controls, @ 11.1.
► If 3 LEDs flash red while you are checking the controls:
Remove the battery and contact your STIHL dealer for
assistance.
The brushcutter has a malfunction.
► If you cannot carry out this work: Do not use your
brushcutter and contact your STIHL dealer for assistance.

6 Charging the Battery, LEDs

6.1

Mounting the Charger on a Wall

The charger can be mounted on a wall.
2
1
a
b
a
► Check the following points when mounting
the charger on a wall:
– Suitable fixing materials.
– The charger is level.
– The following dimensions are maintained:
– a = at least 100 mm
– b (for AL 101) = 75 mm
– b (for AL 300 and AL 500) = 120 mm
– c = 4.5 mm
– d = 9 mm
– e = 2.5 mm
5 Preparing Trimmer for Operation
3
d
e
0458-832-9821-A
e