Mounting The Guard; Mounting The Loop Handle; Mounting And Removing The Mowing Head; Autocut C 6-2 Mowing Head - Stihl FSA 60 R Manual De Instrucciones

English
► Insert the ends of the bump guard (1) into the holes (2) in
the housing.
The bump guard (1) need not be removed.
7.2

Mounting the guard

► Switch off the brushcutter and remove the battery.
1
2
The line limiting blade (1) has already been installed in the
guard (2) and must not be removed.
► Push the guard (2) into the guides on the housing until it
hits the limit stop.
The guard (2) is flush with the housing.
► Insert and tighten down the screws (3).
The guard (2) must not be removed.
7.3

Mounting the Loop Handle

► Switch off the brushcutter and remove the battery.
46
2
2
1
2
► Fit the clamp (4) in the loop handle (3).
► Place the loop handle (3) with clamp (4) on the shaft (5).
► Fit the washers (2) on the screws (1).
► Press the clamp (6) against the shaft (5).
► Insert the screws (1) through holes in the loop handle (3)
and clamps (4 and 6).
► Fit and tighten down the nuts (7) firmly.
3
7.4

Mounting and Removing the Mowing Head

7.4.1

AutoCut C 6-2 mowing head

Mounting the Mowing Head
► Switch off the brushcutter and remove the battery.
1
► Position the mowing head (1) on the shaft (2).
► Hold the mowing head (1) with your hand.
7 Assembling the Trimmer
1
2
3
4
5
6
7
3
2
0458-832-9821-A
1