Level 1 Programming (On-Off Functions) - Nice Spin10KCE Instrucciones Y Advertencias Para El Instalador

7.2.2) Level 1 programming (ON-OFF functions)

By default level 1 functions are set as shown in tables 15 and 15a, but can be modified at any time as shown in tables 16 and 16a. Take
care during modification procedures, as there is a maximum time interval of 10 seconds between pressing one key and another; otherwise
the system exits the procedure automatically memorising the changes made up to that time.
Table 16: To modify the ON-OFF functions in "programming on power-up" mode
1. Switch off SPIN (for example by removing fuse F1)
2. Press and hold [Set]
3. Switch on SPIN (for example by inserting fuse F1)
4. Wait for the flashing signal indicating control unit start-up and keep [Set] pressed until L1 starts to
flash (approx. 6s)
5. Release the key [Set] when led L1 starts to flash
6. Press key [ ] to move the flashing led to the led associated with the function to be modified
7. Press [Set] to change the status of the function (short flash = OFF; long flash = ON)
8. Wait 10s to exit the programming mode automatically after the maximum time interval.
Note: points 6 and 7 can be repeated during the same programming phase to set other functions to ON or OFF.
Table 16a: To modify the ON-OFF functions in "standard programming" mode
1. Press and hold [Set] for approx. 3s
2. Release the key [Set] when led L1 starts to flash
3. Press key [ ] to move the flashing led to the led associated with the function to be modified
4. Press [Set] to change the status of the function (short flash = OFF; long flash = ON)
5. Wait 10s to exit the programming mode automatically after the maximum time interval.
Note: points 3 and 4 can be repeated during the same programming phase to set other functions to ON or OFF
GB
Example
SET
L1 SET 6s
L1 SET
SET
10s
Example
3s
SET
L1
SET
SET
10s
17