Installation Instructions - Standard Installation
STEP 11A INSTALL OVERLAY PANELS (Cont.)
Custom Handles Optional
• If you are using custom handles, the handle must be
properly secured to the overlay panel before sliding the
panel into the trim.
• The cabinet manufacturer will supply the custom handle
and hardware.
• Reinstall the handle side door trim, using all 6 supplied
flat-head screws, plus the 6 flat-head screws originally
installed in the handle door trim.
Reinstall all original screws.
• Install a supplied bracket onto the top of the door, using
a Phillips head screwdriver and the 2 screws provided.
Hand-tighten the screws into the end caps. Do not
overtighten; damage will occur.
• Clean the aluminum trim with rubbing alcohol - do
not use alcohols with oil or lanolin that will prevent
adhesion of double-sided tape.
• Slip the aluminum cover trim onto the top bracket to
check the fit. The aluminum cover trim has a slot on
each end which fits the bracket.
• Remove the trim. Peel away a few inches of the
adhesive backing.
31-1000450 Rev. 1
IMPORTANT: The tape is very sticky and strong. Once
it adheres to a surface, it cannot be removed without
damaging both surfaces. Do not install the trim
before the final wood panels are in place. Be sure
to align the trim carefully before removing the paper
backing.
• Carefully place the aluminum cover trim onto the top
bracket so that the bracket is inside the cover trim. Use
the top to bottom grooves along the handle side to align
the cover trim accurately. Align the bracket with the
screw holes in the top of the door.
• Pull the tape a few inches at a time while pressing the
trim against the door. Press and hold approximately 10
seconds before continuing along the length of the door.
• Install another bracket at the bottom of the door to
secure the cover trim. Use a stubby Phillips head
screwdriver and the 2 screws provided.
•
NOTE: Make sure there are no gaps in the installation.
• Follow the same procedure on the opposite door.
Top Bracket
Slide aliminum
trim over top
bracket.
23
Top Bracket
Secure top
bracket with
2 screws.