Step 7 Level Refrigerator; Step 8 Alternate Anti-Tip Procedure - Monogram ZISB36 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation Instruction - Stainless Steel Installation
STEP 6 ANTI-TIP PROCEDURE (Cont.)
• Cut a 2" x 4" block, 35" (88.9 cm) long and secure the
block to the mounting brackets provided using #12 or
#14 wood screws.
• Secure the bracket
with wood block to
the back wall so that
it is 84" (213.36 cm)
from the finished
floor. Use #12 or #14
wood screws. See
the illustration.
• The screws must
penetrate at least
one inch into the
vertical wall studs.
• If metal wall studs, use self-tapping sheet metal
screws in place of wood screws.
IMPORTANT: When the refrigerator is installed under
a soffit or if there is not enough height for this method
of security, brackets cannot be used. Proceed to step
7 to level the refrigerator and then to step 8 to secure
refrigerator to cabinets.
The refrigerator must be
secured to prevent tipping.
Connect power cord:
• Before pushing the refrigerator into the opening, plug
the power cord into the receptacle. The water filter
guard will need to be removed for access (some
models). Remove the 3 screws holding it in place. If
access is still too tight, remove the 2 screws holding
the water filter bracket and move aside. Open the
grille panel and reach into the opening at the back
to grasp the power cord. Pull the power cord into the
opening as you push the refrigerator back. Secure the
bracket and guard with the original screws.
• Gently push refrigerator into the opening with hands
against front corners.

STEP 7 LEVEL REFRIGERATOR

All models have 4-point leveling. The front is supported
by leveling legs, the rear is supported by adjustable
wheels. Both are accessible from the front of the
refrigerator.
• To level the back of the refrigerator, turn the 7/16" hex
nut located above the front wheels. Turn clockwise to
raise or counterclockwise to lower the refrigerator.
• For front leveling, use a
1-1/4" open-end wrench.
• Adjust height of refrigerator
to match installation cutout
opening 84-1/2"
(214.63 cm). The
refrigerator should be level
and plumb with cabinetry.
NOTICE: The rear leveling
wheels and front leveling
legs are limited to a maximum height adjustment of 1"
(2.54cm). If the installation requires more than 84-1/2"
(214.63 cm) height, the installer should elevate the
refrigerator on a sheet of plywood or runners. Cabinetry
trim could also be added across the top of the opening
to shorten the opening. If you attempt to raise
the refrigerator more than 1" (2.54 cm), you will
damage the front leveling legs and the rear leveling
wheels. Make adjustments in small increments.
STEP 8 ALTERNATE ANTI-TIP
PROCEDURE
The refrigerator must be secured to prevent tipping.
• Raise the grille panel to access case trim.
• Use a 3/16" bit to drill four evenly spaced clearance
holes through the metal top case trim.
38
31-1000450 Rev. 1

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Zis420Zisb42Zis480Zisb48

Tabla de contenido