Premaintenance Procedures; Raising The Seat; Lubrication; Greasing The Bearings - Toro TimeCutter SS 4235 Manual Del Operador

Ocultar thumbs Ver también para TimeCutter SS 4235:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Premaintenance
Procedures
Raising the Seat
Make sure the motion
control
levers are locked in the
park position.
Lift the seat forward.
The following
components
can be accessed
by raising
the seat:
Serial plate
Service decal
Seat adjustment
bolts
Fuel filter
Battery
and battery
cables
Lubrication
Greasing the Bearings
Service Interval:
Every 25 hours--Grease
all
lubrication points.
Grease Type:
No. 2 General Purpose Lithium Base
Grease
1. Park the machine
on a level surface
and disengage
the blade control
switch.
.
.
Move the motion control levers outward to the
park position, stop the engine, remove the ke3, and
wait for all moving parts to stop before leaving the
operating position.
Clean the grease
fittings
(Figure
26 and Figure
27)
with a rag. Make sure to scrape any paint off of the
front
of the fitting(s).
1.
Front caster tire
Figure 26
G014522
Figure 27
Located on the seat pan underside
1.
Read the instructions
before servicing or
performing maintenance.
2.
Check tire pressure every
25 operating hours.
3.
Grease every 25 operating
hours.
4.
Engine
28

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido