Operating, Transportation, Maintenance And Storage Parameters - TEUFELBERGER CEclimb Manual De Instrucciones

OPERATING, TRANSPORTATION, MAINTENANCE AND STORAGE PARAMETERS

OPERATING, TRANSPORTATION, MAINTENANCE AND STORAGE PARAMETERS
Note: For operating, transportation, maintenance and storage parameters also consult the speci-
fic instructions for use for each PPE component of CEclimb.
Operating conditions
- 30° to

+ 50° C
Storage and transportation conditions
+15° to

+25° C
Excessive

pressure or
compaction
Cordage maintenance
Water-domestic

supply quality
(≤ 30°C)
Hardware maintenance
Water

(≤ 40°C)
Drying
Hang in well

ventilated space
Disinfection
Water

(≤ 20°C)
Corrosive Substances
Keep PPE away from corrosive acids, bases, liquids, vapours, gasses etc. If you think damage has
occurred as a result of contact with an aggressive substance:
1) Quarantine the product and label it in an obvious way so that it can not be used by mistake;
2) Send as much information as possible about your concerns to the manufacturer; and
3) Do not use the product again unless the manufacturer replies, in writing, that it may be returned to service.
16
≤ WLL
 
Dry, clean and
 
chemically
neutral surfaces
and environ-
ment
Excessive
 
moisture
Mild detergent
 
Mild detergent
 
(pH 5.5 to 8.5)
+15° to +25°C
 
Ethanol Quar-
 
tenary ammoni-
um compounds
reinforced with
chlorohexidine
at the minimum
concentration
to be effective
Shock load Abrasive and /

or sharp edges
Ventilation Excessive heat

or direct heat
sources
Nibbling pests Corrosive or

aggressive
substances
Gentle hand Pressure wash

washing
Clean with soft Flush with com-

brush and rinse pressed air and
with water leave to dry
(≤ 30°C)
Direct sunlight Excessive heat

or direct heat
sources
Duration - Rinse after

≤ 1 hour
disinfection with
water
(≤ 30°C)
Contamination

Sharp edged

objects
UV-radiation

Thumble dry

Lubrication

with silicone
based lubricant
(karabiners), or
SAE30 mineral
oil (pulley)