Troubleshooting Guide - Di4 Jet Pressing Infinity Manual De Instrucciones

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

Regularly clean the ceramic soleplate with a damp, non-metallic washing pad.

Wipe the exterior of the Steam Station with a soft cloth.

Do NOT use abrasive cleaners, detergent or other chemicals to clean the Steam Station.

Self-clean Mode

When cleaning, the steam hole of the soleplate will discharge a lot of sewage, please be prepared well in

advance. The iron has an intelligent reminder for cleaning mode and active cleaning mode respectively.

The intelligent reminder for cleaning mode means after accumulates to 36 hours using, the power in-

dicator will blink and beep for three times to remind the user to clean the iron, then long press the power

switch for 6 seconds until the power indicator blink and beep for 3 times again, this is just the time for

pressing the trigger, the iron will enter into cleaning mode and begin to discharge the sewage from the

steam hole of the soleplate; It will automatically exit the cleaning model after cleaning for 1 minute, and

the power indicator will stop blinking and beep for 3times.If the user need to exit the cleaning mode at

any time, please press 6 second until the power indicator stop blinking and beep for three times, then

cleaning mode is finished.

Change anti-scale cartridge

depending on the water hardness in your region the water softening anti-scale cartridge should be

replaced every 3-6 months.

Note: Do not use the unit without the water softening cartridge!

1- Remove the water tank from the station.

2- Pull anti-calc cartridge downwards from the water tank and remove it for changing.

Note: Be careful - there can be water inside the cartridge body.

Install a new water-softening cartridge to its place