Troubleshooting - Di4 Duo 2600 Manual De Instrucciones

TROUBLESHOOTING

PROBLEM POSSIBLE CAUSE
Soleplate is not
Connection problem
heating even
Temperature control is in MIN position
though iron is
turned on.
Not enough water in tank
Steam control is selected in non-
Iron does not
steam position.
produce steam
Selected temperature is lower than
that specified to use with steam.
Not enough water in tank
Spray function
does not work
Steam jet function was used very
Steam jet and
frequently within a short period.
vertical steam
Iron is not hot enough
jet function
does not work
The iron The temperature setting is too low to
leaking
produce steam.
This product complies with European Directive 2012/19/EU on electrical and electronic devices,
known as WEEE (Waste Electrical and Electronic Equipment), provides the legal framework applicable
in the European Union for the disposal and reuse of waste electronic and electrical devices. Do not
dispose of this product in the bin, instead going to the electrical and electronic waste collection centre
closest to your home.
We hope that you will be satisfied with this product.
20
SOLUTION
check main power supply cable,plug and outlet.
If in cordless ironing, check that the pilot light turns
on when the iron is placed on the stand.
Fill water tank
Set steam control between positions of minimum
steam and maximum steam(see"iron chart").
Select a higher temperature
Fill water tank
Put iron on horizontal position and wait before
using steam jet function.
Adjust to higher temperature to steam ironing.
Put iron in vertical position and wait temperature
indicator light turns off.
The variable steam knob must be set
on"0"position until the iron is hot.