TEUFELBERGER pulleySAVER Manual De Instrucciones página 5

ATTENTION
This product is only meant for use as a re-
placement part for TEUFELBERGER's pulley-
SAVER system. Therefore, never use it alo-
ne, without pulleySAVERs other components.
After all, as a single component, i.e., without
the other components of pulleySAVER, it has
NOT been type-examined and DOES NOT
comply EN 795B standards.
This replacement part may only be
exchanged by a competent person or
under the supervision of such competent
person. Please be sure to observe the
present instructions for use!
You can also have TEUFELBERGER carry
out the replacement of this component for a
fee. To do so, please send the product to the
mentioned address! TEUFELBERGER Fiber
Rope GmbH, Vogelweiderstrasse 50, 4600
Wels, Austria. If you are not sure as to
whether you have the necessary know-
ledge, skills, and experience, it is absolu-
tely necessary that you consult a compe-
tent person or TEUFELBERGER.
TEUFELBERGER is not responsible for any di-
rect, indirect or incidental consequences/da-
mage that occur(s) during or after the use of
WARNING
The use of our products can be dangerous. Our products may only be used for their intended
purpose. They must particularly not be used for lifting as specified in EU directive 2006/42/EC.
The customer is responsible that the user has been trained in the safe use of the product and
in accompanying safety precautions. Be aware of the fact that the product can cause dama-
ge if wrongly used, stored, cleaned or overloaded. Check national safety regulations, industry
recommendations and standards for local requirements.
TEUFELBERGER and 拖飞宝
®
this product and that result(s) from improper
use, especially from incorrect assembly.
For a replacement, only use the replace-
ment part approved by the manuf-
acturer and supplied together with this
Manufacturer's Information document. Never
use it for any purpose other than the one
described below. Before proceeding to use
your pulleySAVER again, be sure to verify that
the replacement part has been exchanged
correctly. If you do not have the necessary
experience, skills, and knowledge for this
task, please consult a competent person or
the manufacturer.
When using this product, be sure to observe
the Manufacturer's Information for pulleySA-
VER. All pieces of information provided with
regard to transport, storage, cleaning, and
service life also apply to pulleySAVERs whose
components has been replaced.
The component is just one of the components
of the pulleySAVER system – by replacing it,
it is possible to continue using the system,
provided that all of pulleySAVERs other
components are in an appropriate conditi-
on. To assess the condition, please observe
are internationally registered trademarks of the TEUFELBERGER group.
®
GENERAL
5