Oakley Double Tap Manual De Instrucciones página 10

8 | DOUBLE TAP INSTRUCTION MANUAL
ADJUSTING THE CHRONOGRAPH HANDS
When the chronograph is reset with button "B," the two chronograph hands return to the zero position. If these hands
do not align precisely with the zero position (such as after the battery is replaced), use the following procedure to
adjust them.
TO ADJUST THE CHRONOGRAPH HANDS
1. If the chronograph hands currently show a measured
time, use button "B" to reset them near the zero position.
Note that the hands must be stopped before using
button "B" to reset them. If necessary, use button "A"
to stop the hands.
2. Unscrew the crown from the case. Pull the crown out
to the second click position (b).
3. Push button "A" and button "B" simultaneously and
keep them pressed for at least 2 seconds.
4. Adjust the chronograph hands by doing the following:
• Press button "A" to adjust the chronograph hand
that counts seconds. (Press and hold the button for
continuous movement.)
• Press button "B" to finish with that hand and move
on to the other hands.
5. Push the crown back in. Gently turn the crown
clockwise until it screws back into the case. Be
careful not to over tighten the crown, as this will
damage the mechanism.
Hour Hand
Chronograph
Minutes
Counter
Date
Chronograph
Second Counter
Button A
Minute Hand
Crown
Second Hand
Button B