Mower Deck - Briggs & Stratton Snapper RPX210 Instrucciones De Instalación

Never use a battery charger to directly start the engine.
Use only a fully charged battery properly installed.
Never charge the battery with the NEGATIVE (-) black cable
attached to the battery terminal. Keep the loose black cable
away from the battery.
Make sure the ignition is OFF and the starter insert is
1
removed.
Charge battery according to the instructions provided
2
by the charger manufacturer.
After charging attach positive (+) cable (red) fi rst.
3
Cover (+) terminal with boot (red).
4
Attach negative (-) cable (black).
5
Wash hands after handling.
6
5 Install the Seat
Install hardware.
1
Attach the harness.
2
6 Install the Steering Wheel
Straighten front tires foward.
1
Orient steering wheel center spoke towards seat.
2
Hand start nut then tighten to 27 Nm (20 lb-ft).
3
Press on cover
4
7 Roll the Tractor off Crate
Place deck in Transport Position (if equipped) OR
1
Place deck in HIGHEST Height of Cut Position.
Release the parking brake.
2
Unlock roll release lever (two options).
3
WARNING
With the help of another person, carefully guide
4
tractor off back of crate.
Lock roll release lever.
5
8 Check the Tire Pressure
The tires may be over-infl ated for shipment.
WARNING
Over-infl ating tires may cause them to explode
which could result in serious injury.
DO NOT infl ate the tires above the maximum pressure
(stamped on the sidewall of the tires).
Check the Oil Level
9
See operator's manual for additional information.
1
Place tractor on a fl at, level surface.
2
Lift tractor hood and remove dipstick.
3
With a clean cloth wipe dipstick.
4
Insert dipstick.
5
Remove dipstick.
6
Keep oil level in the operating range.
7

Mower Deck

Wheels
10
NOTE: Install wheels into lowermost hole.
NOTE: 96cm decks have two (2) gauge wheels; 107cm
decks have four (4) gauge wheels.
Leveling
11-1
Preparation
Place tractor on flat, level surface.
1
Turn front wheels forward.
2
Turn PTO (blade) switch to OFF.
3
4 Set cutting height to middle position.
Lock parking brake.
5
Remove key.
6
Remove spark plug wire.
7
Side-to-Side
11-2
Wear heavy protective gloves.
1
WARNING
Cutting blades are sharp and can cause injury. Use
heavy protective gloves when handling cutting blades.
Rotate blades side-to-side.
2
Measure distance from outer tips of blades to ground.
3
Diff erence between right blade tip (A) and left blade
tip (B) should be less than 3mm (1/8").
Lower the mower deck.
4
5 Remove belt cover.
Place the mower deck to the MID-HEIGHT of cut
6
position.
Adjust as shown until correct measurement is
7
achieved.
Lower the mower deck.
8
Install covers.
9
17
en