Attaching The Anti-Tilt Brackets To The Wall - Gaggenau RY 492 Instrucciones De Instalación

1. Attaching the anti-tilt brackets
to the wall
ã
WARNING
Risk of injury and damage!
Assure that there are no electrical wires or
plumbing in the area which the screws could
penetrate.
ã
WARNING
Risk of injury! Always wear safety glasses and
other necessary protective devices or apparel
when installing or working with dowels.
Notes:
– Each appliance requires 2 anti-tilt brackets.
– The set supplied, contains fastening screws for
various subsurfaces. Select the fastening screws
corresponding to the local conditions.
– If the anti-tilt brackets, and therefore the appliance,
cannot be securely attached with the supplied
fastening screws, another suitable method must be
used to attach the appliance securely.
The anti-tilt brackets (a) must overlap the appliance by at
1
least 2 / " (54 mm) to ensure that the appliance is
8
stable.
If the minimum overlap cannot be observed due to
structural conditions, these can be overcome by the
attachment of a suitable device, e.g. an adequately
dimensioned beam (b) behind the brackets.
The length of the plank should correspond to the width
of the installation niche!
1. Determine the fastening points of the anti-tilt
brackets.
Determine the actual dimensions according to the
section "Dimensions of the installation niche".
2. Screw on the anti-tilt brackets tightly. Re-examine to
make sure that the screws are firmly tightened.
12
Important notes for fastening with dowels and screws:
– Not recommended for use in light-weight masonry
material such as cinder block.
– Not recommended for use in new concrete which
has not had time to cure.
– Do not use spiral-flute counterbores (countersinking
tool) to drill the holes.