Wayne Dalton 9100 Instrucciones De Instalación Y Manual Del Propietario página 12

2
Attaching Fully Adjustable
Flagangle to Vertical Track
Tools Needed:
NOTE: If quick install fl agangle was
installed in Step 1, skip this step and
None
continue with Step 3. If not, complete
this step.
Hand tighten the fl agangle to the vertical
track using (2) 1/4" - 20 x 9/16" large
head ribbed track bolts (or stud plate if
included) and (2) 1/4" - 20 fl ange hex
nuts.
Secure the fl ange nuts after fl agangle
spacing is complete (Step 13).
3
Tools Needed:
Position the horizontal angle as shown.
Place tabs of horizontal angle in the key
Hammer
slot of horizontal track. Using a hammer,
tap the horizontal angle towards the
curved end of the track until the hole in
track and angle are aligned. Set tracks
aside.
NOTE: For larger doors, a full length
horizontal angle may or may not be
spot welded to the horizontal track. If
the horizontal angle is not welded, the
horizontal angle will be installed as
shown.
12
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Horizontal Angle
FULLY ADJUSTABLE FLAGANGLE
1/4"- 20
FLANGE HEX
NUTS
VERITCAL TRACK
TABS
HOLE
HORIZONTAL TRACK
HORIZONTAL ANGLE
1/4" - 20 X 9/16"
LARGE HEAD RIBBED
TRACK BOLTS
STUD PLATE
HORIZONTAL
ANGLE
KEY SLOT
HOLE
HORIZONTAL
TRACK
HORIZONTAL
HORIZONTAL
TRACK
ANGLE
HORIZONTAL
TRACK
TABS