Connector Panels - NDS Aesculap Manual De Instrucciones

Connector Panels

Notes
1. An S-Video signal may be applied via 2 BNC terminated cables to the Y and C labeled BNC connectors or a
DIN 4 terminated cable, but not both.
2. RGBS, VGA or YPbPr signals may be applied via the HD-15 connector or the R / Pr, G / Y, B / Pb, HS / C-
SYNC and VS BNC connectors. If the HD-15 connector is used for inputs, then the BNC connectors may not
be used for inputs.
3. Set the REDRIVE switch to Off when the RGBS, VGA and YPbPr signals will not be daisy chained to
another display. The REDRIVE switch is set to On when the RGBS, VGA or YPbPr signals will be daisy
chained to a second display.
Electrical Symbols
Equipotentiality:
This symbol appears next to the display's Potential Equalization Conductor. (ground post)
Open (Off) Switch:
This symbol appears on the open, or off, side of the display's rocker switch.
Closed (On) Switch:
This symbol appears on the closed, or on, side of the display's rocker switch.
EndoVue 19
EndoVue 19 with SDI
EndoVue 15
EndoVue 15 with SDI
3
2