Electrical Connection - Balluff BTL7-A/C/E/G5-M-K-SR32/SR115 Serie Manual De Instrucciones

BTL7-A/C/E/G5 _ _ -M _ _ _ _ -K(8)-SR32/SR115/_ _ _
Micropulse Transducer - Rod Style
4
Installation and connection (continued)
Supporting rod made of non-magnetizable material
Fig. 4-7: Example 2, transducer installed with supporting rod
4.4.1 Connector SR32
Pin -A510 -G510
1 Not used
1)
2
3 10...0 V 10...–10 V
4
5 0...10 V –10...10 V
6
7
8
Unassigned leads can be connected to the GND on the controller side but not to the shield.
1)
Reference potential for supply voltage and EMC-GND.
2)
3) The voltage outputs may exhibit a minimal offset to the harmonized current output.
Tab. 4-2: Connection assignment BTL7...-SR32
4.4.2 Connector SR115
Pin -A510 -G510
1 0 V (pin 3)
2
3 10...0 V 10...–10 V
4
5 0...10 V –10...10 V
6
7
8
Unassigned leads can be connected to the GND on the controller side but not to the shield.
1)
2) Reference potential for supply voltage and EMC-GND.
Tab. 4-3: Connection assignment BTL7...-SR115
10 english
Magnet
(e.g. BTL-P-1028-15R)
-C500 -C570 -E500
0...20 mA 20...0 mA 4...20 mA
0 V
10...0 V 3)
La (programming input)
0...10 V
3)
GND
2)
10...30 V
Lb (programming input)
-C500 -C570 -E500
Not used
1)
0 V (pin 5)
Not used
1)
La (programming input)
0...20 mA 20...0 mA 4...20 mA
GND
2)
10...30 V
Lb (programming input)
4.4

Electrical connection

Depending on the model, the electrical connection is made
using a cable or a connector (BTL7...-SR32, BTL7...-SR115).
The connection or pin assignments for the respective version
can be found in Tab. 4-2 to Tab. 4-4.
Note the information on shielding and cable
routing on page 11.
-E570
20...4 mA
Fig. 4-8:
-E570
Fig. 4-9:
20...4 mA
Pin assignment of SR32 (view
from above on transducer), 8-pin
M16 circular plug
Pin assignment of SR115 (view
from above on transducer), 8-pin
M12 circular plug