Preparation; Filter Installation; Operation; Start/Stop - Sharp KC-G60EU Manual De Funcionamiento

PREPARATION

FILTER INSTALLATION

1
Remove the Back Panel.
2
Remove the plastic bag from the each
filter.
HEPA Filter

OPERATION

START/STOP

START

CLEAN ION SHOWER MODE

The unit releases Plasmacluster ions with strong airflow and
collects dusts while decreasing static electricity for 10 min-
utes. After that, the DUST sensor sensitivity is automatically
set to "HIGH"and quickly detects impurities
and clean the air powerfully for 50 minutes.
KC-G60_50_40EU_OM_WEST.indb 7
Back Panel
Deodorizing Filter
STOP
NOTE
• When the operation finishes after
60 minutes, the unit will return
to the prior operation mode. It is
able to change the other mode
during this mode.
• The Plasmacluster Ion can not
be turned "OFF". (Ref. E-10)
Always be sure to remove the
power plug from the wall outlet.
3
Install the filters in the correct order as
shown.
4
Install the Back Panel.
2
3
NOTE
• When replacing the filter, making a memo of the start of
use date is recommended.
INTELLIGENT MODE
The fan speed is automatically controlled depending on the 7
detection. (Ref. E-1)
AUTO MODE
The fan speed is automatically controlled depending on the
5 detection. (PM2.5 / Usual dust / Temperature /Humidity /
Light)
NOTE
• Front Display, Cleanliness Monitor and Air Outlet LED
automatically switch ON and OFF based on room
brightness. (When light control is set to "Auto". Ref. E-11)
E-7
HEPA Filter
Tag
Deodorizing Filter
Click
1
3
(KC-G60EU / KC-G50EU)
(KC-G40EU)
2017-08-30 06:33:17