ABB free@home Manual Del Usuario página 14

—
6. Integrating wireless devices
1. Switch on the mains power supply of the free@home wireless devices
 After power-up the devices are in discovery mode for 30 minutes
2. In the user interface of the System Access Point select „Settings - free@home
wireless - Search for wireless devices"
 Devices that are in discovery mode are integrated automatically into the system.
The scanning process ends 10 minutes after the last device has been found.
3. Integrated devices are listed in the „Device list" of the user interface. Use the serial
numbers to check whether all installed devices have been found.
4. If a device has not been found, it may not have been in discovery mode. The reason
for this could be that
a. the discovery time has expired
b. the device has already been coupled with a different system
Reset the device to the factory settings and start a new scanning process
Resetting to factory settings (example)
1. Press and hold the bottom of the rocker for at least 25 seconds.
2. The bottom LED light will start flashing after 10 seconds.
3. After another 10 seconds, the LED will start flashing rapidly. After another 5 seconds,
the LED light will turn off.
4. Release the bottom of the rocker within the next 10 seconds.
5. Then press the bottom of the rocker. The lower LED light will stay on.
Press the bottom of the rocker again. The previous actions must be completed
within 5 seconds.
6. The device will now return to factory settings and restart.
Visit https://www.abb.com/freeathome for product updates.
Recommendation: Register your system at https://mybuildings.abb.com for
automatic software updates.
Note: The free@home remote access is is free for first 12 month with voucher in the box.
14