Serta Motion Custom II Manual De Instrucciones página 23

setting up two bases
If simultaneous operation of two bases is desired, use the SmartSync
STEP 1
Unplug base from power source .
STEP 2
Disconnect the power-down box cable from each splitter cable .
Make note where the cable was plugged in .
STEP 3
Connect the male end of the sync cord to each splitter cable .
Insert it into the same port that you disconnected the power-down
box from in Step 2 .
USB Charger
Power-Down Box
the electronics of both bases together.
Control Box
Sleeptracker®
Sensor(s)*
Splitter
STEP 4
Connect each power-down box male connection to the sync cord
female connection (Refer to the illustration below) .
STEP 5
Plug base back into the power source .
STEP 6
Check to ensure all cords are securely attached . Both remotes will
now operate both bases simultaneously (If the remotes become
unpaired, see page 19) .
Sleeptracker®
Processor
Control Box
Sleeptracker®
Sensor(s)*
Sync Cord
Cord to connect
™
Splitter
USB Charger
Power-Down Box
21