Be Cool pivot Manual De Instrucciones página 65

the seat position adjustment handle to set it to the cor-
rect level.
Step 2: as shown in figure 2, release the ISOFIX connec-
tor. Pull the ISOFIX adjustment handle and the ISOFIX
connector will automatically come out.
Step 3: as shown in figure 3, if you want to remove the
ISOFIX, pull the ISOFIX adjustment handle with one hand
and press the ISOFIX connectors towards the base with
the other hand.
Step 4: as shown in figure 4, before installing the ISO-
FIX, hold the anti-rotation strap on the rear of the frame
and pull it outwards. Then, temporarily place it on the
headrest.
Step 5: as shown in figure 5, before inserting the two
ISOFIX connectors into the ISOFIX anchor points, the
ISOFIX indicator window will be red.
Step 6: as shown in figure 6, insert the two ISOFIX
connectors firmly into the ISOFIX anchor points on the
vehicle seat until you hear them click into place. Then
the ISOFIX indicator window will turn green. To release
the ISOFIX connectors, press the green button and the
indicator window will turn back to red.
Step 7: as shown in figure 7, with one hand pull the ISO-
FIX adjustment handle and with the other hand push the
base of the child safety seat to lock it into position. It is
not necessary to pull the ISOFIX adjustment handle if the
ISOFIX is locked.
b- Anti-rotation strap installation for group I
Step 1: as shown in figure 1, pass the anti-rotation strap
through the middle of the headrest of the child safety
seat.
Step 2: as shown in figures 2 and 3, pull the anti-rotation
strap halfway up the headrest of the vehicle seat and
hook it onto the rear anchor (consult the user manual
from the vehicle manufacturer, if necessary, in order to
remove the vehicle headrest to make it easier to install
the child safety seat).
Step 3: as shown in figure 4, tighten the anti-rotation
strap until the adjuster turns green. Jiggle the safety seat
to check that the anti-rotation strap is tightened correct-
ly. If you want to release the anti-rotation strap, press the
button so the adjuster swivels at an angle.
c- Harness installation for group I
Step 1: as shown in figure 1, pull part of the anti-rotation
strap.
Step 2: as shown in figure 2, rotate the child safety seat
90 degrees (see the rotation function section on page 8).
EN
65