Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
E N G L I S H
f)
It is advisable to lubricate the spotting arm
articulation periodically. To accomplish this
operation introduce some oil drops in the
proper lubrication hole.
g) Clean the air pipe from any impediment
(dirty) that stops the airflow during the
ventilation phase.
h) Check the wear of the board padding and, if
necessary, substitute it. The board padding
is considered a part of the normal wear and
tear since ironing tends to matt the padding
and decrease the aspiration and steaming
capacities of the board.
Problem:
BREAKDOWNS ON THE BOILER AND ON THE ELECTRONIC LEVEL
1. The water feeding valve is
open,
but
the
station alarm is on.
2. Water
is
sucked
during steam generation at
ironing start.
C H A P T E R 4
BREAKDOWNS
1. Water is not fed into the boiler
electronic
and the station is signalling
the error.
back
2. Causes:
a) The
been
hours.
b) The
water
closed
evening.
c) The ball valve is out of
order and does not close
properly.
i)
Carry out a visual inspection inside the boiler,
at least once a year, to control the conditions
of the inside walls and the presence of
possible scales and/or corrosions. Carefully
clean the inside of the pipe containing the
probe.
j)
Disassemble the safety valve and clean the
joint, on which is assembled, of any scaling.
Also check that the valve is not obstructed.
k) Check the condition of all the labels and
plates
instructions).If they are in poor condition,
replace them.
Causes:
CONTROL
machines
has
not
used
for
several
ball
valve
on
the
pipe
was
not
on
the
previous
Page 4-6
on
the
machine
(warnings
Action:
1. Check that water is actually
fed into the machine and, if
necessary,
passages
as
Pos. 5.
2. With
the
operation, drain water from
the boiler by opening the
boiler drain ball valve slowly
until
the
re-loading water. Now close
the drain cock.
E N G L I S H
and
clean
the
indicated
at
machine
in
pump
starts
Publicidad
Tabla de contenido
