Safety Precautions; Grounding Instructions - Nobles Speed Scrub 2001 Manual De Operación Y De Piezas

SAFETY PRECAUTIONS

This machine is intended for commercial use. It is
suited to scrub floors in an indoor environment and is
not constructed for any other use. Use only
recommended pads, brushes and cleaning detergents.
The following safety alert symbols are used throughout
this manual as indicated in their description.
WARNING: To warn of hazards or unsafe
practices which could result in severe personal
injury or death.
FOR SAFETY: To identify actions which must be
followed for safe operation of equipment.
The following information signals potentially dangerous
conditions to the operator or equipment:
FOR SAFETY:
1. Do not operate machine:
– Unless trained and authorized.
– Unless operator manual is read and
understood.
– In flammable or explosive areas unless
designed for use in those areas.
– With damaged cord or plug.
– If not in proper operating condition.
– In outdoor areas.
– In standing water.
– With the use of additional extension cords.
Only use manufacturer's extension cord
equipped with machine which has proper
capacity and is grounded.
2. Before operating machine:
– Make sure all safety devices are in place
and operating properly.
3. When using machine:
– Do not run machine over cord.
– Do not pull machine by plug or cord.
– Do not pull cord around sharp edges or
corners.
– Do not unplug by pulling on cord.
– Do not stretch cord.
– Do not handle plug with wet hands.
– Keep cord away from heated surfaces.
– Go slow on inclines and slippery surfaces.
– Use care when reversing machine.
– Always follow safety and traffic rules.
– Report machine damage or faulty
operation immediately.
– Do not carry riders on machine.
Speed Scrubt 2001 Electric (11–01)
Home Find... Go To..
– Follow mixing and handling instructions
on chemical containers.
4. Before leaving or servicing machine:
– Stop on level surface.
– Turn off machine.
– Unplug cord from wall outlet.
5. When servicing machine:
– Unplug cord from wall outlet.
– Avoid moving parts. Do not wear loose
jackets, shirts, or sleeves.
– Block machine tires before jacking up.
– Use hoist or jack of adequate capacity to
lift machine.
– Use manufacturer supplied or approved
replacement parts.
WARNING: Hazardous Voltage. Shock or
electrocution can result. Unplug machine before
servicing.
WARNING: Flammable materials can cause
an explosion or fire. Do not use flammable
materials in tank(s).
WARNING: Flammable materials or reactive
metals can cause an explosion or fire. Do not pick
up.

GROUNDING INSTRUCTIONS

Machine must be grounded. If it should
malfunction or breakdown, grounding provides a
path of least resistance for electrical current to
reduce the risk of electrical shock. This machine
is equipped with a cord having an
equipment–grounding conductor and grounding
plug. The plug must be plugged into an
appropriate outlet that is properly installed in
accordance with all local codes and ordinances.
Do not remove ground pin; if missing, replace
plug before use.
Grounded
3 Hole Outlet
Ground Pin
OPERATION
(120V)
3