Connecting Power Cord; Machine Operation; Pre-Operation Checks - Nobles Speed Scrub 2001 Manual De Operación Y De Piezas

CONNECTING POWER CORD

1. Connect 23M (75 ft) extension cord to machine's
pigtail cord.
2. Plug extension cord into a grounded wall outlet
(Figure 9)
Grounded
3 Hole Outlet
Ground Pin
FIG. 9
FOR SAFETY: Do not operate machine with the
use of additional extension cords. Only use
manufacturer's extension cord equipped with
machine which has proper capacity and is
grounded.

MACHINE OPERATION

PRE–OPERATION CHECKS
1. Sweep and dust mop floor.
2. Inspect power cord for damage, replace
immediately if damaged.
3. Check that a pad/brush is installed.
4. Check that squeegee is installed.
FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
1. Adjust control grips to a comfortable operating
height (three settings). Squeeze together two
levers under console to raise or lower control grips
(Figure 10).
FIG. 10
Speed Scrubt 2001 Electric (11–01)
Home Find... Go To..
2. Lower squeegee by releasing squeegee lift lever
from the lock position (Figure 11).
FIG. 11
3. Lower brush head, step down firmly on top brush
lift pedal and push pedal forward to lower
(Figure 12).
FIG. 12
4. Turn vacuum switch to the on position.
5. Push solution flow lever forward to desired flow
rate. Solution will immediately begin to flow once
lever is activated (Figure 13).
FIG. 13
To adjust the maximum solution flow rate, turn
solution flow adjustment knob down to increase or
up to decrease (Figure 14).
OPERATION
7