Metra 99-9714WR Instrucciones De Instalación página 11

Attention: The Axxess Updater App can also be used to program the following (3) sub-sections
as well, pending that the interface has been initialized and programmed.
Radio Type
If the L.E.D. flashes do not match the radio that is connected, change the radio type.
1. After (3) seconds of turning the key on, press and hold the Volume-Down button on
the handlebar until the L.E.D. in the ASWC-1 goes solid.
2. Release the Volume-Down button; the L.E.D. will go out indicating we are now in
Changing Radio Type mode.
3. Refer to the Radio Legend to know which radio number you would like to have
programmed.
4. Press and hold the Volume-Up button until the L.E.D. goes solid, and then release.
Repeat this step for the desired radio number.
5. Once the desired radio number has been selected, press and hold the Volume-Down
button on the handlebar until the L.E.D. goes solid. The L.E.D. will remain on for
about (3) seconds while it stores the new radio information.
6. Once the L.E.D. goes off, the Radio Type mode will then end. You can now test the
handlebar controls.
Note: If at any time the user fails to press any button for a period longer than ten
seconds, this process will abort.
HANDLEBAR CONTROL SETTINGS
(CONT)
Radio Legend
1 - Eclipse (Type 1) 6 - Pioneer/Jensen
2 - Kenwood
7 - Alpine
3 - Clarion (Type 1)
8 - Visteon
4 - Sony / Dual
5 - JVC 9 - Valor
10 - Clarion 14 - Parrot
(Type 2)
15 - XITE
11 - Metra OE
16 - Philips
12 - Eclipse
17 - TBD
(Type 2)
13 - LG 18 - JBL
REV. 9/11/2020 INST99-9714WR
11