Final Assembly - Metra 99-9714WR Instrucciones De Instalación

INITIALIZING THE INTERFACE
b. Tap the Volume Up button on the handlebar at a moderate pace until the L.E.D. stops flashing
rapidly.
c. After a few seconds the LED should stop flashing rapidly, and then go out for approximately 2
seconds.
d. After approximately 2 seconds there will be a series of 7 Green flashes, (6) short, and (1) long. The
(1) long flash represents that the ASWC-1 detected the vehicle.
Tip: Knowing this will help to troubleshoot, if need be.
e. The LED will pause for another 2 seconds, and then flash Red up to 17 times depending on which
radio is connected to the interface. Refer to the L.E.D. feedback section for information.
f. This is the end of the auto detection stage. If the ASWC-1 detected the radio and vehicle
successfully, the L.E.D. will light up solid.
g. Test the handlebar controls for proper operation. Refer to "Handlebar Control Settings" before
proceeding onto the next step.
6. Turn the key to the off position.
(CONT)
1. Reassemble the fairing in reverse order of disassembly.

FINAL ASSEMBLY

REV. 9/11/2020 INST99-9714WR
9