Metra 99-9714WR Instrucciones De Instalación página 12

Remap Buttons
The interface has the ability to change the button assignment for the handlebar control
buttons, except Volume-Up and Volume-Down. Follow the steps below to remap the
handlebar control buttons.
1. Within the first twenty seconds of turning the ignition on, press and hold the Volume-Up
button on the handlebar until the L.E.D. goes solid.
2. Release the Volume-Up button, the L.E.D. will then go out; The Volume-Up button has
now been programmed.
3. Follow the list in the Button Assignment Legend to reference the order in which the
handlebar control buttons need to be programmed.
Note: If the next function on the list is not present on the handlebar, press the Volume-Up
button for (1) second until the L.E.D. comes on, and then release the Volume-Up button. This
will tell the ASWC-1 that this function is not available, and it will move on to the next function.
4. To complete the remapping process, press and hold the Volume-Up button on the
handlebar until the L.E.D. in the ASWC-1 goes out.
12
HANDLEBAR CONTROL SETTINGS
(CONT)
Button Assignment Legend
1 - Not allowed
2 - Not allowed
3 - Seek-Up/Next
4 - Seek-Down/Prev
5 - Mode
6 - Mute
7 - Preset-Up
8 - Preset-Down
9 - Power
* Not applicable in this application
Note: The aftermarket radio may not have all of these commands. Please refer to the manual
provided with the radio, or contact the radio manufacturer, for specific commands recognized by
that particular radio.
10 - Band
11 - Play/Enter
12 - PTT (push to talk)
13 - On-Hook
14 - Off-Hook
15 - Fan-Up *
16 - Fan-Down *
17 - Temp-Up *
18 - Temp-Down *
|
386.257.1187 MetraOnline.com